Hi Michael,
In some case, one wants to add one error to a group, so is it possible add "group" into "error_element"? For example, the power supply error of one group power supply, misalignment of one girder. I have tried the example "NSLS-II-GirderMisalignment" and it's no problem. However, if the "error_element" command have the card "group" , as"name" or "element_type " , it will be very easy to add errors. Is the elegant have this function or can add this function?
Thank you very much!
Best regards,
Cai
Is it possible add "group" into "error_element"?
Moderators: cyao, michael_borland
-
- Posts: 1951
- Joined: 19 May 2008, 09:33
- Location: Argonne National Laboratory
- Contact:
Re: Is it possible add "group" into "error_element"?
Cai,
That's a very good suggestion, albeit a fairly complicated one to implement. I'll put it on the list for future improvements.
--Michael
That's a very good suggestion, albeit a fairly complicated one to implement. I'll put it on the list for future improvements.
--Michael