Multiple matching locations in single command file
Posted: 26 Jan 2009, 13:46
I have a lattice with 3 matching locations (in beamline order: D,S,R) . Each location has its own set of quads to use for optimizing.
I successfully matched at each location with three separate elegant runs, using the matched lattice of the previous run as the input for the next run.
I was also able to get a good result when I matched the D and S locations simultaneously. I cannot get a good solution by matching all three simultaneously. Here's what I want to know...can I set up the command file so that the input of one match is the solution of the previous match? In otherwords chain the matches together?
I've attached the command file that DOES NOT produce a good solution (along with the lattice)
thanks,
Michele
I successfully matched at each location with three separate elegant runs, using the matched lattice of the previous run as the input for the next run.
I was also able to get a good result when I matched the D and S locations simultaneously. I cannot get a good solution by matching all three simultaneously. Here's what I want to know...can I set up the command file so that the input of one match is the solution of the previous match? In otherwords chain the matches together?
I've attached the command file that DOES NOT produce a good solution (along with the lattice)
thanks,
Michele