Hi,
I've never been very successful in using the optimizer in elegant. I'm attaching a simple lattice file with a request/challenge to get the fit to converge. I have four 90-degree FODO cells. I simply want to move the phase advance (both planes) and maintain the same Twiss parameters at the exit. If this exercise is done with DIMAD, the fit converges and is done in less than a fraction of a second. With elegant, the way I currently have the optimizer configured, it takes a good part of a minute and does not converge. I'm fitting 6 parameters (Bx, By, ax, ay, psix, psiy) with 9 available knobs. I'd love for someone to show me what I'm doing wrong!
Thanks,
chris
Fits with Fitting
Moderators: cyao, michael_borland
Fits with Fitting
- Attachments
-
- fit_test.lte
- (578 Bytes) Downloaded 373 times
-
- fit_test.ele
- (2.11 KiB) Downloaded 364 times
-
- Posts: 1933
- Joined: 19 May 2008, 09:33
- Location: Argonne National Laboratory
- Contact:
Re: Fits with Fitting
Chris,
Please try the attached file. I think the main problem was the huge step sizes.
-Michael
Please try the attached file. I think the main problem was the huge step sizes.
-Michael
- Attachments
-
- fit_test.ele
- (2.11 KiB) Downloaded 394 times