problem with alter_element applied on RFCA element
Posted: 11 Nov 2016, 11:55
Hi Michael,
Today I noticed an issue with the alter_element when applied to the RFCA element. I have attached a simplified example that reproduces my observation. To reproduce my problem I have prepared two .ele file one as the alter_element command that set the voltage to what it is in the .lte file while the other does not have the alter_element command.
The sequence is as follows:
run elegant test_noalter.ele
sddsanalyzebeam cryomodule_end.out -pipe=out | sddsprintout -pipe=in -col=pAverage
gives 2.801039e+02
run elegant test.ele
sddsanalyzebeam cryomodule_end.out -pipe=out | sddsprintout -pipe=in -col=pAverage
gives 1.780903e+03
I have double check and think my rpn expressions are all OK. Thank you for any help.
-- Philippe.
Today I noticed an issue with the alter_element when applied to the RFCA element. I have attached a simplified example that reproduces my observation. To reproduce my problem I have prepared two .ele file one as the alter_element command that set the voltage to what it is in the .lte file while the other does not have the alter_element command.
The sequence is as follows:
run elegant test_noalter.ele
sddsanalyzebeam cryomodule_end.out -pipe=out | sddsprintout -pipe=in -col=pAverage
gives 2.801039e+02
run elegant test.ele
sddsanalyzebeam cryomodule_end.out -pipe=out | sddsprintout -pipe=in -col=pAverage
gives 1.780903e+03
I have double check and think my rpn expressions are all OK. Thank you for any help.
-- Philippe.