Dear Michael and others,
I am not sure if this is a bug, but would like to ask about the units of FSE. In the elegant manual, it says the units of FSE of KQUAD, KSEXT etc., , are "M" (meter?). The units, "M", are also found in the output file .fin. What is "M"?
I would like to apply, for example, the strength error of 0.1 %, so I thought I just put "FSE=0.001", but was not able check if this is right or not by checking .erl file.
Thank you,
Takahiro
Units of fractional strength error in magnets
Moderators: michael_borland, soliday
-
- Posts: 1945
- Joined: 19 May 2008, 09:33
- Location: Argonne National Laboratory
- Contact:
Re: Units of fractional strength error in magnets
Takahiro,
Those are typographical errors. FSE has no units, so a 0.1% error would be FSE=0.001.
Thanks for pointing out the mistake. It will be fixed in the next release.
--Michael
Those are typographical errors. FSE has no units, so a 0.1% error would be FSE=0.001.
Thanks for pointing out the mistake. It will be fixed in the next release.
--Michael
Re: Units of fractional strength error in magnets
Hi Michael,
Thank you for the quick answer!
Takahiro
Thank you for the quick answer!
Takahiro