Hello everybody,
I would like to calculate amplifications factors in the Elettra2.0 ring, but I receive the error message:
"Terminated by SIGSEGVProgram trace-back:"
Clearly I am doing something wrong, but I could not figure out what. My files are in attachment.
Thank you in advance for help,
Simone
amplification fators
Moderators: cyao, michael_borland
-
- Posts: 1945
- Joined: 19 May 2008, 09:33
- Location: Argonne National Laboratory
- Contact:
Re: amplification fators
Simone,
Unfortunately, this is a bug that slipped past the regression tester. I wasn't able to find a full workaround. However, you can get the uncorrected amplification factors using the attached file elettra_run1b.ele
Also, I fixed the bug and ran the simulation. Results attached.
--Michael
Unfortunately, this is a bug that slipped past the regression tester. I wasn't able to find a full workaround. However, you can get the uncorrected amplification factors using the attached file elettra_run1b.ele
Also, I fixed the bug and ran the simulation. Results attached.
--Michael
- Attachments
-
- 2016-10-24.zip
- (1.34 MiB) Downloaded 311 times
-
- Posts: 46
- Joined: 09 Jun 2008, 01:19
Re: amplification fators
Thank you Michael. It runs. Fine. Best,
S.
S.
-
- Posts: 49
- Joined: 13 Oct 2016, 09:17
Twiss parameters
Hello everbody,
How should I fix Terminated by SIGSEGV problem while computing twiss parameters.
Earlier there was get_para_name() error. Its fixed up by changing the editor and beamline.
Thank you in advance.
Aamna
How should I fix Terminated by SIGSEGV problem while computing twiss parameters.
Earlier there was get_para_name() error. Its fixed up by changing the editor and beamline.
Thank you in advance.
Aamna
- Attachments
-
- elegant.tar.gz
- (2 KiB) Downloaded 289 times
-
- Posts: 1945
- Joined: 19 May 2008, 09:33
- Location: Argonne National Laboratory
- Contact:
Re: amplification fators
Aamna,
As you may have figured out, the problem was in the lattice file, which lacked continuation characters and separators in the beamline definition. See attached.
--Michael
As you may have figured out, the problem was in the lattice file, which lacked continuation characters and separators in the beamline definition. See attached.
--Michael
- Attachments
-
- Int.lte
- (6.08 KiB) Downloaded 322 times