Hi,
I want to model the effect of LSC in a 1 meter drift space using LSCDRIFT (toy example)
I am a bit confused about the description of cutoff frequency in the manual.
Does LOW_FREQUENCY_CUTOFF0 actually mean the highest frequency that LSCDRIFT will take into account ?
Say, if it is 0.25, then anything after 0.25*Nyquist frequency will be set to zero.
Similarly, if HIGH_FREQUENCY_CUTOFF0 is set to 0, does that mean smoothing filter will be applied to the whole frequency spectrum ?
Thanks.
Here I also attach my toy example for your reference.
TAN
cut off frequency option in LSCDRIFT
Moderators: cyao, michael_borland
cut off frequency option in LSCDRIFT
- Attachments
-
- elegant.lte
- (2.26 KiB) Downloaded 210 times
-
- elegant.ele
- (767 Bytes) Downloaded 205 times
-
- Posts: 1933
- Joined: 19 May 2008, 09:33
- Location: Argonne National Laboratory
- Contact:
Re: cut off frequency option in LSCDRIFT
Tan,
The terminology is a bit confusing.
The terminology is a bit confusing.
- HIGH_FREQUENCY_CUTOFF0 and HIGH_FREQUENCY_CUTOFF1 are used to filter out high frequencies, i.e., they provide a low-pass filter. The filter has value 1 for f<HIGH_FREQUENCY_CUTOFF0, value 0 for f>HIGH_FREQUENCY_CUTOFF1, and linear variation in between.
- LOW_FREQUENCY_CUTOFF0 and LOW_FREQUENCY_CUTOFF1 are used to filter out low frequencies, i.e., they provide a high-pass filter. The filter has value 0 for f<LOW_FREQUENCY_CUTOFF0, value 1 for f>LOW_FREQUENCY_CUTOFF1, and linear variation in between.
Re: cut off frequency option in LSCDRIFT
Hi,
Thanks for your explanation.
Is it possible to output the plot of impedance or LSC kick in ELEGANT ?
TAN
Thanks for your explanation.
Is it possible to output the plot of impedance or LSC kick in ELEGANT ?
TAN
-
- Posts: 1933
- Joined: 19 May 2008, 09:33
- Location: Argonne National Laboratory
- Contact:
Re: cut off frequency option in LSCDRIFT
Tan,
Unfortunately, there's no feature now for plotting the LSC impedance. You can calculate it using the formula given on the manual page. The program sddsfdfilter will allow you to easily apply filters of the same time used in elegant.
--Michael
Unfortunately, there's no feature now for plotting the LSC impedance. You can calculate it using the formula given on the manual page. The program sddsfdfilter will allow you to easily apply filters of the same time used in elegant.
--Michael