Page 1 of 1
what's wrong with simulation of transport line orbit correct
Posted: 23 Oct 2009, 03:33
by shancai
hello,
The reference orbit have a change and is not zero.
I don't know what's the reason.
Thank a lot!
Re: what's wrong with simulation of transport line orbit correct
Posted: 28 Oct 2009, 16:35
by michael_borland
Shancai,
I ran your simulation but get a different result, which is attached here.
Can you tell me which version of elegant you are using? The one-to-one trajectory correction was updated in the last release, so it might make a difference.
--Michael
Re: what's wrong with simulation of transport line orbit correct
Posted: 29 Oct 2009, 04:00
by shancai
I use the newest version elegant(22.0.1).The attachment is the log file.
Re: what's wrong with simulation of transport line orbit correct
Posted: 29 Oct 2009, 14:30
by michael_borland
Shancai,
I don't see any obvious problems in the log file. Can you make a tar file of all the output files and post it?
Also, what operating system? 32 or 64 bit?
Thanks--Michael
Re: what's wrong with simulation of transport line orbit correct
Posted: 29 Oct 2009, 19:20
by shancai
Thanks a lot!
My system is 32 bit fedora 11
Re: what's wrong with simulation of transport line orbit correct
Posted: 29 Oct 2009, 20:29
by michael_borland
Shancai,
I can confirm that there is a problem with your simulation for recent versions of elegant. The reason is that you are using CSBEND elements with the default integration parameters. These defaults are not good for most cases (this changes in the next release).
Try setting N_KICKS=12,INTEGRATION_ORDER=4 on all the CSBEND elements. It should fix the problem.
--Michael
Re: what's wrong with simulation of transport line orbit correct
Posted: 06 Nov 2009, 21:10
by shancai
Thanks a lots!
It works.