Page 1 of 1

Parameters

Posted: 02 Sep 2022, 07:05
by fabioluneli
Hi,

I am running the acceptance - fodoScan1 example. I would like to know about the "lattice" parameter
Is there any local where i can find more information about this parameter?

Thank you!

Re: Parameters

Posted: 19 Sep 2022, 13:21
by michael_borland
I'm not sure what you mean, but perhaps you refer to the lattice parameter in the &run_setup command. That parameter names the file that defines the lattice (the layout of magnets and other components).

In that particular example, the file is called lattice.lte

--Michael