Parameters

Moderators: cyao, michael_borland

Post Reply
fabioluneli
Posts: 11
Joined: 10 Feb 2022, 08:08

Parameters

Post by fabioluneli » 02 Sep 2022, 07:05

Hi,

I am running the acceptance - fodoScan1 example. I would like to know about the "lattice" parameter
Is there any local where i can find more information about this parameter?

Thank you!

michael_borland
Posts: 1797
Joined: 19 May 2008, 09:33
Location: Argonne National Laboratory
Contact:

Re: Parameters

Post by michael_borland » 19 Sep 2022, 13:21

I'm not sure what you mean, but perhaps you refer to the lattice parameter in the &run_setup command. That parameter names the file that defines the lattice (the layout of magnets and other components).

In that particular example, the file is called lattice.lte

--Michael

Post Reply