Elegant users forum

Dear all, I 'd like to report that I noticed that concat_order switch in &run_setup seems to conflict with the first_is_fiducial switch in &run_control . You can double check by adding concat_order=1 in the examples in bunchComp : both phaseSweep.ele and energySweep.ele show the error "problem with ...

Dear all,
after some deeper reading of the elegant manual I realised I had to set the first_is_fiducial=1 flag , I only now realised it was a fiducialization issue.

Best regards,
Giovanna

Good Morning, I am facing an unexpected difficulty in calculating residual dispersion, I hope you can help me solve it. I have two elegant runs (let's call them run0 and run1) which are identical but for a detail: in the second run, the first RF cavity of the LINAC is changed to have a different vol...

Dear Michael,
thanks for your detailed answer and suggestions!
Regards,
Giovanna

Dear Micheal, thanks for the clarification. I am simulating beam based alignement (DFS) of a LINAC and I would like to see the performance with BPM noise on, I am having a bit of difficulties in figuring out how to extract the information relative to this ... I use &correct command to extract the re...

Dear elegant community of users and collaborators, I want to set up a simulation with non-zero BPM noise level, but not necessarily &correct on . Is there a way embedded in elegant to retrieve the values of the centroid of the beam read by the BPMs with noise on in such a case? Or this is possible o...

Great,
Thanks for the fast and detailed answer

Best regards,
Giovanna

I actualy tried with more than one .erl file, such as the one in the elegant Examples folder:

elegantExample/outboardTrajCorr2/run2.erl

Thanks,
Giovanna

Hello everyone, I am using the sddsload function for MatLab and it works perfectly for all the sdds files produced by elegant but not with the ".erl" files produced with &error_control error_log=%s.erl &end. When I issue the command val=sddsload('test.erl') I get the following error Error using sdds...